Lighter Safety Warnings
1. Working principle
1. This product uses a lithium-ion rechargeable battery. Booster assembly can raise the low voltage of 3.7V to the half-sine high voltage of 7KV with a frequency of around 15KZ, which can generate high frequency and high voltage, shock the air to form are wear with high temperature, and light cigarettes, candles, dry leaves and other combustible materials quickly. Additionally, the conventional gas and fuel oil is replaced by the environmentally-friendly, clean, low-carbon electricity and application of USB interface to charge enables cycle use. It only needs physical access to the are spark to ignite without harmful gases.
2. Product description
2.1 Charge through the USB interface by connection to computers, cell phone chargers and any other chargers with the output voltage of DV 5V $ 0.5V and output current below 3000MA. 2.2Connect the charger first and then disconnect and reconnect the charger, at first-time use or when havingnot used for a long time;
2.2. 1 Built-in smart charging circuit will light the indicator light at the bottom of the product when charging, and the light turns off automatically after a full charge;
2.2. 2Please disconnect the power immediately after fully charged. A charge can be filled within2-3h. Do not leave the fully charged battery connected to a power source, because overcharging will shorten battery life;
2.2. 3 The battery is rechargeable, and one charge can dis charge hundreds of times. Before the battery is fully discharged, immediate charges after use will extend battery life.
2.3 For security reasons, this product has especially multiple protections such as overcharge, over discharge and overload. Lf the heating time is too long, the product will automatically cut off the power supply inside and lock the circuit, so that it cannot continue lo be used.
2.4 For considerations in the use of the product, it does not set the timer off function. Do not continue to use more than 10 seconds, in order to avoid the high temperature to burn the skin and affect the product's life.
2.5 USB charging does not need to inflate or add oil. When using, you only need to use your fingers to spin the bonnet (Figure 1) backward, and the circuit will instantly start to generale the high-frequency voltage, and shock the air to produce high temperature arc.
3. Usage
3.1 When using, you only need to rotate the switch of the bonnet with a finger (Figure 1) backward, contact the combustibles to the are spark to ignite, and it does not produce harmful gases.
Tips: Do not touch the arc place, for there is the risk of high temperature and voltage; please immediately clean up soot and other debris. During the ignition, there will be noise of "zzee, zee" , which is high-voltage power generation. Please use with ease.
3.2 Cherging method
3.2.1 When using, direclly Insert the charging wire into the USB interface in the base of the product, and then access the power to charge the baltery (Figure 3). During charging, the indicator light at the bottom of the product will turn on, and indicator light will turn off automatically after a full charge;
3.2.2 Please unplug the power cord after fully charge, in order to avoid overcharge to alfect battery life. (Figure 4)
4. Warning What you have purchased is a sophisticated product, meeting the highest quality and safety standards. Please follow these safety measures strictly:
4.1 Do not use a sharp object to pierce or burn this product
4.2 Place the product out of the reach of children.
4.3 Other than the authorized service technicians, do not cut open the product by other people;
4.4 Do not place the product into water or other liquids into moisture status. or it will cause a short circuit;
4.5 Do not use this product on any chargers other than the chargeable chargers mentioned above! This could cause explosion;
4.6 This product is not suitable for lighting. Do not continue to use more than 10 seconds, in order to avoid the high temperature to burn the skin and affect product life;
4.7 Please stay away from others and your own face, skin and combustible substances. Make sure the flame has been fully extinguished after use lo avoid danger;
4.8 This product should be away from open flames and heat with more than 50°C. Avoid prolonged sun exposure, especially in a glass case or in a car. Otherwise it will cause overheating, fire or functional decline and reduce the service life;
4.9 Please disconnect the power immediately after full charge. Do not leave the fully charged battery connected to a power source, because overcharging will shorten battery life.
4.10 When lighting cigaretle, you only need lo contact the cigarette to the are crater (Figure 2), which can quickly lit the cigarette. Please clean up the ash and other debris at the arc crater in time, so as not to affect the effect of cigarette lighter. Please do not touch it with your hands.